[Free] 2017(July) EnsurePass Examcollection Cisco 200-120 Dumps with VCE and PDF 121-130

EnsurePass
2017 July Cisco Official New Released 200-120
100% Free Download! 100% Pass Guaranteed!
http://www.EnsurePass.com/200-120.html

CCNA Cisco Certified Network Associate CCNA

Question No: 121 – (Topic 3)

What are three features of the IPv6 protocol? (Choose three.)

  1. optional IPsec

  2. autoconfiguration

  3. no broadcasts

  4. complicated header

  5. plug-and-play

  6. checksums

Answer: B,C,E

Question No: 122 – (Topic 3)

Refer to the exhibit.

image

What is the most appropriate summarization for these routes?

A. 10.0.0.0 /21

B. 10.0.0.0 /22

C. 10.0.0.0 /23

D. 10.0.0.0 /24

Answer: B

Question No: 123 – (Topic 3)

Refer to the diagram.

image

All hosts have connectivity with one another. Which statements describe the addressing scheme that is in use in the network? (Choose three.)

  1. The subnet mask in use is 255.255.255.192.

  2. The subnet mask in use is 255.255.255.128.

  3. The IP address 172.16.1.25 can be assigned to hosts in VLAN1

  4. The IP address 172.16.1.205 can be assigned to hosts in VLAN1

  5. The LAN interface of the router is configured with one IP address.

  6. The LAN interface of the router is configured with multiple IP addresses.

Answer: B,C,F

Question No: 124 – (Topic 3)

What will happen if a private IP address is assigned to a public interface connected to an ISP?

  1. Addresses in a private range will be not be routed on the Internet backbone.

  2. Only the ISP router will have the capability to access the public network.

  3. The NAT process will be used to translate this address to a valid IP address.

  4. A conflict of IP addresses happens, because other public routers can use the same range.

Answer: A

Question No: 125 – (Topic 3)

Which IPv6 address is the all-router multicast group?

A. FF02::1

B. FF02::2

C. FF02::3

D. FF02::4

Answer: B

Topic 4, IP Routing Technologies

Question No: 126 – (Topic 4)

Two routers named Atlanta and Brevard are connected via their serial interfaces as illustrated, but they are unable to communicate. The Atlanta router is known to have the correct configuration.

image

Given the partial configurations, identify the fault on the Brevard router that is causing the lack of connectivity.

  1. incompatible IP address

  2. insufficient bandwidth

  3. incorrect subnet mask

  4. incompatible encapsulation

  5. link reliability too low

  6. IPCP closed

Answer: D

Question No: 127 – (Topic 4)

What are two enhancements that OSPFv3 supports over OSPFv2? (Choose two.)

  1. It requires the use of ARP.

  2. It can support multiple IPv6 subnets on a single link.

  3. It supports up to 2 instances of OSPFv3 over a common link.

  4. It routes over links rather than over networks.

Answer: B,D

Question No: 128 – (Topic 4)

Refer to the exhibit.

image

Which of these statements correctly describes the state of the switch once the boot process has been completed?

  1. As FastEthernet0/12 will be the last to come up, it will be blocked by STP.

  2. Remote access management of this switch will not be possible without configuration change.

  3. More VLANs will need to be created for this switch.

  4. The switch will need a different IOS code in order to support VLANs and STP.

Answer: B

Question No: 129 – (Topic 4)

Refer to the exhibit.

image

The network administrator must establish a route by which London workstations can forward traffic to the Manchester workstations. What is the simplest way to accomplish this?

  1. Configure a dynamic routing protocol on London to advertise all routes to Manchester.

  2. Configure a dynamic routing protocol on London to advertise summarized routes to Manchester.

  3. Configure a dynamic routing protocol on Manchester to advertise a default route to the London router.

  4. Configure a static default route on London with a next hop of 10.1.1.1.

  5. Configure a static route on London to direct all traffic destined for 172.16.0.0/22 to 10.1.1.2.

  6. Configure Manchester to advertise a static default route to London.

Answer: E

Question No: 130 – (Topic 4)

What is the default maximum number of equal-cost paths that can be placed into the routing table of a Cisco OSPF router?

  1. 2

  2. 8

  3. 16

  4. unlimited

Answer: B

100% Free Download!
Download Free Demo:200-120 Demo PDF
100% Pass Guaranteed!
Download 2017 EnsurePass 200-120 Full Exam PDF and VCE
Get 10% off your purchase! Copy it:TJDN-947R-9CCD [2017.07.01-2017.07.31]

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 EnsurePass IT Certification PDF and VCE

Leave a Reply